Göbel Frost protection heating cable 18 m with thermostat

Frost protection heating cable, length: 18m 288 Watt, 230 Volt with thermostat

- guaranteed to keep your water pipe frost-free
- built-in thermostat works independently
- tested VDE safety
- do not install in the browsing area of animals - use only 24 volt heating cable
- not suitable for heating pipes
- in case of additional insulation, do not insulate the thermostat with the cable.
- protect the area that the animals can chew on with a bite guard
- IPX7
- Made in EU
- prevent water pipes from freezing
- thermostat in the heating cable switches the cable on automatically

What to look out for with 230 V heating cables:
- always attach heating cables to the underside of the pipe
- the water pipe must be earthed
- the 230 V heating cables must be plugged in and connected to a power supply with a circuit breaker (FI switch 30 mA)
- the heating cables must not be shortened and should therefore already be ordered in the correct length
- remaining lengths can be wound around the pipe in coils (note that a coil spacing of at least 15 mm must be maintained here). 15 mm must be observed)
- do not bend the heating cable and observe the max. bending radius of approx. 50 mm
- the heating cables can be fixed to the pipe with insulating tape or with aluminium tape
- when used on plastic pipes, the pipe must be wrapped with aluminium tape before the heating cable is laid
- the pipe and the heating cable should be insulated with an insulation of min. 13 mm insulation
- the thermostat of the heating cable should be placed at the coldest position of the pipe
- the thermostat should be only moderately insulated
- do not use 230 V heating cables in the browsing area of animals
- installation must be carried out by a qualified specialist according to VDE0100